Analog Devices EVAL-ADPD188BIZ-SK, User Manual

Page: 3 / 10

EVAL-ADPD188BIZ-SK User Guide UG-1274
Rev. 0 | Page 3 of 10
GETTING STARTED
INSTALLING THE APPLICATIONS WAVETOOL
Download the Applications WaveTool software package from the
EVAL-ADPD188BIZ-SK product page. Unzip the folder and run
Applications_WaveToolx_x_x.exe . Follow the prompts for
software installation, beginning with the setup window shown in
Figure 2.
16756-
002
Figure 2. Applications WaveTool Setup Window
CONNECTING THE EVAL-ADPDUCZ
MICROCONTROLLER BOARD AND THE EVAL-
ADPD188BIZ-SK EVALUATION BOARD
Connect the USB cable to the EVAL-ADPDUCZ evaluation board,
connect the ribbon cable to the EVAL-ADPD188BIZ-SK board,
and switch the power switch to the
ON position (see Figure 3).
When the USB cable is connected, the second light emitting
diode (LED) below the power switch illuminates, indicating that
the on-board battery is being charged. When the power switch
is turned to the
ON position, the LED immediately below the
power switch illuminates, indicating that the EVAL-ADPDUCZ
microcontroller board is on.
SWITCH TO ON
167
56-
003
Figure 3. Connecting the EVAL-ADPDUCZ to the EVAL-ADPD188BIZ-SK
CHECKING THE USB SERIAL CONNECTION IN
WINDOWS
Ensure that the COM port driver is installed correctly. To verify
proper installation of the COM port driver, go to
Control Panel >
All Control Panel Items > System > Device Manager , as shown in
Figure 4. In this case, the proper COM port selection is USB Serial
Port (COM16)
.
The EVAL-ADPDUCZ microcontroller board uses an FT232 USB
universal asynchronous receiver transmitter (UART) IC. If the
USB driver installation does not install properly, refer to the
corresponding FTDI driver installation guide that is compatible
with the operating system being used.
16
75
6-
00
4
Figure 4. USB Serial Port in Windows® 7
The EVAL-ADPDUCZ also contains a Bluetooth® radio that can
be paired with the PC if a wireless connection is desired.
RUNNING THE APPLICATIONS WAVETOOL
To start the Applications WaveTool application, navigate to the
Start menu > Analog Devices > ApplicationsWaveTool and
click ApplicationsWaveTool.
INSTRUCTIONS TO LOAD THE FIRMWARE
It is possible that the EVAL-ADPDUCZ microcontroller board
is loaded with an older version of the firmware at the time that it
was stocked. In this scenario, the user receives the message shown
in Figure 5 when attempting to connect to the WaveTool.
16756
-0
05
Figure 5. Warning Message for Outdated Firmware