Analog Devices EVAL-ADN4693E-1, Quick Start Manual

Page: 5 / 9

User Guide EVAL-ADN4693E-1
EVALUATION BOARD CONFIGURATION
analog.com Rev. 0 | 5 of 9
INPUT AND OUTPUT CONNECTIONS
Table 1 details the digital input and output connections, and Table 2 details the M-LVDS input and output connections.
Table 1. Digital I/O Connections
Connection
DI RO
SMA Connector J1 J2
Terminal Connector J1-4 via R2 J1-4 via R1
Load Capacitor None C2 (not populated)
Termination Resistor R3 None
Table 2. M-LVDS Input and Output Connections
Receiver Transmitter
Connection A B Y Z
SMA Connector J5 J6 J8 J9
Termination Resistor RT2 RT1
JUMPER CONNECTIONS
Table 3 details the jumper configurations.
Table 3. Jumper Configurations
Jumper
Position Description
LK1 A Connects the RE pin of the ADN4693E-1 to VCC, which disables the receiver. This places the RO output into a high impedance state.
B Connects the RE pin of the ADN4693E-1 to the RE connection on the J1-4 screw terminal connector.
C Connects the RE pin of the ADN4693E-1 to GND, which enables the receiver.
LK2 A Connects the DE pin of the ADN4693E-1 to VCC, which enables the driver.
B Connects the DE pin of the ADN4693E-1 to the DE connection on the J1-4 screw terminal connector.
C Connects the DE pin of the ADN4693E-1 to GND, which disables the driver. This places the Y and Z outputs into a high impedance state.
D Connects the DE pin of the ADN4693E-1 to the RE pin of the ADN4693E-1. Set the state of both the DE and RE signals using the LK1 jumper.