UG-1135
Rev. 0 | Page 24 of 45
RESET
To manually reset the
, press and
release the RESET push-button, S1 (see Figure 74). A reset
generator circuit toggles the reset pins on the
to perform a full hardware reset of both devices.
157
89-
069
Figure 74. Manual Reset Push-Button
To generate a reset in software, right click in the empty white bor-
der of the
USB Interface
block in the
Hardware Configuration
tab, and then choose
Device Enable/Disable
from the menu
that appears (see Figure 75). Performing this action once sets
the system reset signal to logic low.
15789-
070
Figure 75. Toggling the Reset Signal in
STATUS LEDS
Six status LEDs provide information about the state of the EVAL-
ADAU1466Z evaluation board (see Figure 76). For additional
information pertaining to the status LEDs, see Table 6.
157
89-
0
71
Figure 76. Status LEDs
