UG-1135
Rev. 0 | Page 5 of 45
3.
When the warning about Windows logo testing appears,
click
Continue Anyway
1578
9-
007
Figure 5.
Hardware Installation
—Windows Logo Testing Warning
The
drivers are now installed. Leave the
connected to
the PC.
Using Windows 7 or Windows Vista
After connecting the
to the USB 2.0 port, Windows 7 or
Windows Vista recognizes the device and installs the drivers
automatically (see Figure 6). After the installation is complete,
leave the USBi connected to the PC.
157
89-
00
8
Driver Installed Correctly
Confirming Proper Installation of the
Drivers
drivers have been installed properly,
take the following steps:
1.
With the
still connected to the USB 2.0 port of the
computer, check that both the yellow I
2
C LED and the red
power indicator LED are illuminated (see Figure 7).
2.
In the Windows
Device Manager
, under the
Universal
Serial Bus controllers
section,(see Figure 8), check that
Analog Devices USBi (programmed)
is displayed.
15
78
9-
0
09
Figure 7. State of
Status LEDs After Driver Installation
15
789-
01
0
Figure 8. Confirming Driver Installation Using the Device Manager
DISABLING THE SELF BOOT SWITCH
When setting up the EVAL-ADAU1466Z evaluation board, ensure
that the first switch of the four-position DIP switches, S3, is in the
off position, which is away from the printed label on the evaluation
board.
The default position of this switch is the off (disabled) position,
which prevents the
from executing a self boot oper-
ation at power-up. When the switch is in the on position, the LED
D7 is illuminated, and a self boot operation is executed, causing
the
to attempt to load code from an EEPROM when
it powers up or comes out of reset.
