Analog Devices EVAL-AD7175-2SDZ, User Manual

Page: 3 / 12

EVAL-AD7175-2SDZ User Guide UG-AD7175-2
EVAL-AD7175-2SDZ QUICK START GUIDE
RECOMMENDED QUICK START GUIDE
Follow these steps to set up the board:
1.
Disconnect the SDP-B board from the USB port of the PC.
Install the EVAL-AD7175-2SDZ software from the
enclosed CD. Restart the PC after installation.
2. Connect the EVAL-SDP-CB1Z board to the
EVAL-AD7175-2SDZ board, as shown in Figure 2.
3. Fasten the two boards with the enclosed plastic
screw washer set.
4. Connect the external 9 V power supply to Connector J5 of
the
EVAL-AD7175-2SDZ board as shown in Figure 2. Set
LK2 to Position B.
5. Connect the SDP board to the PC via the USB cable. For
Windows® XP, you may need to search for the SDP drivers.
Choose to automatically search for the drivers for the
SDP-B
board if prompted by the operating system.
6. Launch the EVAL-AD7175-2SDZ software from the
Analog Devices subfolder in the
Programs
menu.
QUICK START NOISE TEST
Use the following procedure to quickly test the noise
performance:
1.
Insert Link LK5 to Link LK9 to initiate the noise
performance test mode. In this mode, analog input
channels short to the REFOUT pin.
2. Click
Start Sampling
to acquire samples from the ADC
(see Figure 7).
The
Samples
numeric control in the top right corner of the
main window sets the number of samples collected in each
batch.
Figure 2. Hardware Configuration, Setting Up the EVAL-AD7175-2SDZ
TBD
Rev. Pr.C | Page 3 of 12