UG-867
EVAL-AD5629RSDZ/EVAL-AD5669RSDZ User Guide
Rev. 0 | Page 8 of 14
HOW TO USE THE SOFTWARE
STARTING THE SOFTWARE
To run the
EVAL-AD5629RSDZ
/
EVAL-AD5669RSDZ
software,
take the following steps:
1.
Connect the evaluation board to the
SDP-B
board and
connect the USB cable from the
SDP-B
board to the PC.
2.
Power the
SDP-B
board and the evaluation board by
connecting 5 V to Connector J2.
3.
Click Start > All Programs > Analog Devices >
AD5629R/AD5669R > AD5629R/AD5669R Evaluation
Software. While the software connects to the evaluation
board, the message in Figure 3 displays.
Figure 3. Connection Message
If the
SDP-B
board is not connected to the USB port when the
software launches, a connectivity error displays (see Figure 4).
Figure 4. Connectivity Error
Connect the
SDP-B
board to the USB port of the PC, wait at
least 40 sec for the
SDP-B
board to boot, click Rescan, and
follow the instructions.
Alternatively, the software can be used without an evaluation
board. The software runs in simulation mode displaying
expected outputs based on the input data. The main window
of the
AD5629R
/
AD5669R
evaluation software then opens, as
shown in Figure 5.
Figure 5.
AD5629R
/
AD5669R
Evaluation Software Main Window
13430-
003
13430-
004
13430-
005
