Analog Devices EVAL-AD5341DBZ, User Manual

Page: 4 / 12

UG-982 EVAL-AD5341DBZ User Guide
Rev. 0 | Page 4 of 12
EVALUATION BOARD SOFTWARE QUICK START PROCEDURES
INSTALLING THE SOFTWARE
The EVAL-AD5341DBZ evaluation software is compatible with
Windows® Vista (64-bit/32-bit) and Windows 7 (64-bit/32-bit).
Install the software before connecting the
SDP-B board to the
USB port of the PC to ensure that the SDP-B board is recognized
when it connects to the PC.
To install the
EVAL-AD5341DBZ software, take the following
steps:
1.
Start the Windows operating system.
2. Download the installation software from the EVAL-
AD5341DBZ evaluation board page.
3. Run the setup.exe file from the installer folder if it does not
open automatically.
4. Power up the EVAL-AD5341DBZ as described in the
Power Supplies section after installation is completed.
5. Connect the EVAL-AD5341DBZ to the SDP-B and the
SDP-B to the PC using the USB cable included in the
evaluation kit.
6. Proceed through any dialog boxes that appear to
finalize the installation when the software detects the
EVAL-AD5341DBZ .
RUNNING THE SOFTWARE
To run the EVAL-AD5341DBZ software, take the following
steps:
1.
Connect the EVAL-AD5341DBZ to the SDP-B and connect
the USB cable between the SDP-B and the PC.
2. Power up the EVAL-AD5341DBZ as described in the
Power Supplies section.
3. Click Start > All Programs > Analog Devices > AD5341 .
If the SDP-B is not connected to the USB port when the software is
launched, a connectivity error displays (see Figure 2).
Connect the
SDP-B to the USB port of the PC and wait a few
seconds. When the SDP-B and the EVAL-AD5341DBZ are
detected, the display updates (see Figure 3).
14517-
002
Figure 2. Connectivity Error
14517-
003
Figure 3. Hardware Select
Alternatively, the software can be used without an evaluation
board. The software runs in simulation mode displaying expected
outputs based on the input data. The main window of the
AD5341
evaluation software then opens, as shown in Figure 4.