Regulatory Compliance
The Blackfin A-V EZ-Extender is designed to be used solely in a labora-
tory environment. The board is not intended for use as a consumer end
product or as a portion of a consumer end product. The board is an open
system design which does not include a shielded enclosure and therefore
may cause interference to other electrical devices in close proximity. This
board should not be used in or near any medical equipment or RF devices.
The Blackfin A-V EZ-Extender has been certified to comply with the
essential requirements of the European EMC directive 2004/108/EC and
therefore carries the
“CE” mark
.
The Blackfin A-V EZ-Extender has been appended to Analog Devices,
Inc. EMC Technical File (EMC TF) referenced
DSPTOOLS1
, issue 2
dated June 4, 2008 and was declared CE compliant by an appointed Noti-
fied Body (No.0673) as listed below.
Notified Body Statement of Compliance: Z600ANA1.023 dated
December 2, 2004.
Issued by: Technology International (Europe) Limited
56 Shrivenham Hundred Business Park
Shrivenham, Swindon, SN6 8TY, UK
The Blackfin A-V EZ-Extender contains ESD (electrostatic discharge) sen-
sitive devices. Electrostatic charges readily accumulate on the human body
and equipment and can discharge without detection. Permanent damage
may occur on devices subjected to high-energy discharges. Proper ESD pre-
cautions are recommended to avoid performance degradation or loss of
functionality. Store unused extender boards in the protective shipping pack-
age.
