ADSP-BF592 EZ-KIT Lite Evaluation System Manual
1-5
Using ADSP-BF592 EZ-KIT Lite
Step 2:
Attach the provided cord and appropriate plug to the 5V power
adaptor.
1. Plug the jack-end of the power adaptor into the power connector
P9
(labeled
5V
) on the EZ-KIT Lite board.
2. Plug the other side of the power adaptor into a power outlet. The
power LED (labeled
LED5
) is lit green when power is applied to the
board.
3. Power the emulator (if used). Plug the jack-end of the assembled
power adaptor into the emulator and plug the other side of the
power adaptor into a power outlet. The enable/power indicator is
lit green when power is applied.
Step 3 (if connected through the debug agent):
Verify that the yellow
USB monitor LED (labeled
ZLED2
) and the green power LED (labeled
ZLED1
) on the debug agent are both on. This signifies that the board is
communicating properly with the host PC and ready to run CCES.
Session Startup
It is assumed that the CrossCore Embedded Studio software is installed
and running on your PC.
Note: If you connect the board or emulator first (before installing
CCES) to the PC, the Windows driver wizard may not find the
board drivers.
1. Navigate to the CCES environment via the
Start
menu.
Note that CCES is not connected to the target board.
Summary of Contents for ADSP-BF592 EZ-KIT Lite
Page 4: ......
Page 67: ...A B 4 3 2 ADSP B S...
Page 77: ...Index I 4 ADSP BF592 EZ KIT Lite Evaluation System Manual...
