A n a Je t® 3 0 0 0 /6 0 0 0
Q U IC K S T A R T IN S T A L L A T IO N G U ID E
V .1 .0
SAFETY
INFORMATION
FCC Statement (USA):
•
Note
: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
•
Caution
: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
•
Caution
: Properly shielded and grounded cables and connectors must be used for
connections to host computer (and/or peripheral) in order to meet FCC emission limits.
User Information on Electrical and Electronic Equipment:
•
Caution:
An AC adapter with ferrite core must be used for RF interference
suppression.
Note to Users in California (USA):
•
Perchlorate Material. Special handling may apply.
See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Warning for Electrical and Electronic Equipment (For EU countries only):
•
This equipment is compliant with Class A of CISPR 32.
In a residential environment, this equipment may cause radio interference.
•
1) Properly shielded and grounded cables and connectors must be used for
connections to a host computer (and/or peripheral) in order to meet emission
limits.
•
2) An AC adapter with a ferrite core must be used for RF interference
suppression.
Laser Emitter Warning and Laser Aperture Warning
•
The Obstruction Sensor detects any obstruction on the Print Table, such as wrinkles
on the shirts, which can damage the print heads. On the left-hand side of the printer,
there is an Obstruction Laser Diode, which generates the laser. On the right-hand
side, there is the Obstruction Laser Sensor.
Laser
•
This equipment complies with the requirements of IEC60825-1:2014 for class 2 laser
product. This equipment complies with Beam Divergence (Half Angle) : 0.6 mRad. .
This equipment contains a 650 nanometer wavelength. The maximum output power
of the light source is 1 milliwatt.
•
WARNING:
Although the laser used in the AnaJet® 3000™ and AnaJet® 6000™
printer is low power, exercise care so that laser does not shine directly into the eyes.
The laser can cause injury.
•
CAUTION
—Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
•
Mangled Hand Warning: Keep body parts away from gears and moving parts.
