AMYPOWER ALLTRACK R3 & R SERIES - Owner’s Manual (Rev. A)
13
WARNING
N. CG TILT POWER ACCESSORY
Pinch Point
Avoid putting hands or fingers near the power tilt
mechanism while in operation.
The powered CG Tilt accessory for this chair has a
maximum user weight capacity range from 300 lbs up
to 400 lbs depending on the chair configuration. Never
exceed the specified capacity while operating the
powered actuator.
WARNING
O. 11” SEAT LIFT POWER ACCESSORY
Pinch Point
Avoid putting hands or fingers near the power seat lift
mechanism while in operation.
The powered lift modular accessory for this chair has
a maximum user weight capacity of up to 300 lbs or
400 lbs depending on your chair configuration. Never
exceed this capacity while operating the powered
actuator.
WARNING
P. POWER RECLINE
Pinch Point
Avoid putting hands or fingers near the power recline
mechanism while in operation.
The maximum user weight capacity for the power recline is
from 300 lbs up to 400 lbs depending on the chair
configuration. Exceeding this weight capacity could lead to
injury and/or permanent damage to the equipment.
WARNING
Q. POWER ELEVATING LEGREST ACCESSORY
Pinch Point
Avoid putting hands or fingers near the power elevating
legrests or center mount mechanism while in operation.
The power legrest accessory for the Alltrack R has a maximum
user weight capacity of up to 300 lbs or 400 lbs depending on
your chair configuration. Never exceed this capacity while
operating the powered actuator.
WARNING
R.
TRANSIT USE
Your chair has been manufactured with built-in Transport
Brackets on.
These transport brackets have not been crash-tested in
accordance with WC-19. Use these transport brackets only to
secure an unoccupied wheelchair during transport
1. NEVER let anyone sit in this chair while in a
moving vehicle.
2. NEVER transport this chair in the front seat of a
vehicle. It may shift and interfere with the driver
3. ALWAYS secure this chair so that it cannot
roll or shift.
4. Do not use any chair that has been involved in a
motor vehicle accident.
VIII. SET-UP, ADJUSTMENT AND USE
NOTES
1. Work Surface for Set-Up:
Use a flat surface, such as a table, to assemble, adjust and
check your chair. This makes the steps easier and helps
ensure a correct set-up.
2. Fasteners:
Many of the screws and bolts on this chair are special
high- strength fasteners and may have special coatings.
Many nuts are of the Nylock type. They have a plastic
insert to help prevent loosening.
Only use screws, bolts and nuts provided by Amypower.
WARNING
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or
cause damage to chair parts.
3. If bolts or screws become loose, tighten them as
soon as you can. Loose bolts or screws can cause
damage to other chair parts causing them to fail.
3. Washers & Spacers:
Note the position of washers and spacers before
disassembly.
To avoid damage to the frame, replace all washers
and spacers when you reassemble parts.
TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you
may need the following tools:
Combined Phillips and flat screw driver
Standard metric wrenches from 10mm
Metric Allen wrenches from 5mm
Imperial wrenches from 1/4" to 9/16"
Imperial Allen wrenches from 5/64" to 1/4"
These tools can be found in standard hardware
stores.
2. Torque Wrench:
If you plan to adjust and maintain this chair
yourself, Amypower recommends that you use a
torque wrench.
NOTE- The wrench must measure inch-pounds (N.m). You
can buy a torque wrench and proper sockets from a hardware
store.
