AMX TDS Installation Overview
51
AMX TDS (Television Delivery System)
6.
Assign a unique IP (multicast) address to the Tuner:
a.
Select
Tuner A Setup
to access the
Tuner A Setup
page.
b.
Enter a unique IP address for Tuner A in the
Tuner Output/IP Address
field, and click
Save
.
6) Configure the Receiver(s)
The basic steps outlined below apply to each Receiver in the system.
1.
Click the
Rx Setup
command button to open the
Receiver Setup (Network Settings)
page (see the
The Receivers are listed under
Manage Unit
in the
Receiver Setup - Network Settings
page, each
one indicated by it’s MAC address. The MAC address for each Receiver is printed on a label
located on the bottom panel of the device.
If you do not see the installed Receivers indicated in this list, refresh your browser window.
2.
Rename each Receiver, so that you can identify them easily in the future.
a.
Select a Receiver in the
Manage Unit
list.
b.
Enter a new name for the selected Receiver in the
Unit Name
text field.
c.
Click
Update
.
3.
Enable Channels on the selected Receiver:
a.
Click
Channel Setup
to open the
Receiver Setup - Channel Settings
page.
b.
Select the channels that you want to receive on the selected Receiver.
Select
All Units
to apply the channel selection on this page to all Receivers in the system.
c.
Click
Save
.
Scaling and Centering the Picture
If the picture needs to be scaled or centered:
1.
Disconnect the Receiver from the network and reboot.
2.
Press
MENU
on the remote to display the menu page on the monitor.
3.
The
Player Setup
options allow the user to adjust display scale and position.
Assigning a DTV-RC01 Remote Controller To a Specific Receiver
1.
In the Digital TV Configuration Manager (see the
Digital TV Configuration Manager
page 53), enter a 2-digit numeral/character combo (any combination of 0-9 and A-F), in the
Remote
Control Number
field of the
Receiver Setup - Output Settings
page (FIG. 71).
The default Remote Control Number for DTV-RC01 remote controllers is
6E
.
2.
Click
Save
to load the new remote control address into the Receiver.
A IPv4 multicast address should be used, ranging from 224.0.0.0 to
239.255.255.255. Avoid any reserved addresses.
After booting up a Rx (or Tx), it must first be allocated an IP address (if DHCP
enabled) before appearing in the device list. Depending on the Network, this may
take a couple of minutes.
FIG. 71
Receiver Setup - IR Settings
See the Receiver Setup - Output Settings (DTV-RX02-HD)
more information.
Summary of Contents for TDS
Page 8: ...vi AMX TDS Television Delivery System Table of Contents ...
Page 86: ...Digital TV Configuration Manager 78 AMX TDS Television Delivery System ...
Page 90: ...Serial Commands 82 AMX TDS Television Delivery System ...
Page 105: ...FAQs and Recommendations 97 AMX TDS Television Delivery System ...