Installation & Setup
19
Precis DSP Instruction Manual
3.
From the Comm menu, select Connect.
4.
From the Options menu, select Rediscover VMs.
If the system discovery fails again, contact technical support (see page 20).
Executing a Test Switch Using APGraphic EQ
Execute a test switch to verify the system is working properly before attaching all inputs and outputs.
Before executing the test switch
, make sure the first two source devices and the first two destination
devices are connected to the input and output connectors.
Note:
For directions for executing a test switch using BCS commands, see page 31.
We recommend executing a test switch that routes Input 1 to Output1 and Output 2.
To execute a test switch using the CrossBar in APGraphic EQ:
1.
From the main interface, open the Options menu and select Show > CrossBar View.
2.
Click the crosspoints for Input 1 to Output 1 and Input 1 to Output 2 (inputs are on the left and
outputs are across the top).
The system is ready for fine-tuning; see page 21.
FIG. 7
Click crosspoints to route test switch
Crosspoint for Input 1 to Output 1
Crosspoint for Input 1 to Output 2
Tip: Place the cursor over a crosspoint
to display the input/output numbers for
that crosspoint.
