Installation Guide
NXR-ZGW-PRO
NetLinx ZigBee Pro Gateway
COMPLIANCES
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15.105 FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encourage to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on circuit different from that to which
the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This equipment complies to CFW47, Part 15 Subpart C of the FCC rules. Any
changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC rules subject to the following two
conditions:
1.
This device may not cause harmful interference
2.
This device must accept all interference received, including interference
that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 centimeters (8 inches) between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
RSS Warning Statement
This device has been designed to operate with the antennas listed below, and
having a maximum gain of 2.0 dB. Antennas not included in this list or having a
gain greater than 2.0 dB are strictly prohibited for use with this device. The
required antenna impedance is 50 ohms.
Acceptable antenna for use with the transmitter is Pulse W1030.
To reduce potential radio interference to other users, the antenna type and its
gain should be chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that permitted for successful communication.
