Address Table Settings
100
Instruction Manual - NXA-ENET8-POE+
Issuing MAC Address Traps
Use the MAC Address > MAC Notification pages to send SNMP traps (i.e., SNMP notifications) when a dynamic MAC address is
added or removed.
The following table lists the options on this page:
Perform these steps to enable MAC address traps at the global level:
1.
Click
MAC Address
>
MAC Notification
.
2.
Select
Configure Global
from the Step list.
3.
Configure MAC notification traps and the transmission interval.
4.
Click
Apply
.
Perform these steps to enable MAC address traps at the interface level:
1.
Click
MAC Address
>
MAC Notification
.
2.
Select
Configure Interface
from the Step list.
3.
Enable MAC notification traps for the required ports.
4.
Click
Apply
.
MAC Address - MAC Notification Options
Configure Global
MAC Notification Traps
Issues a trap when a dynamic MAC address is added or removed. (Default: Disabled)
MAC Notification Trap Interval
Specifies the interval between issuing two consecutive traps. (Range: 1-3600 seconds; Default: 1
second)
Configure Interface
Port
Port Identifier (Range: 1-10/26/28/52)
MAC Notification Trap
Enables MAC authentication traps on the current interface. (Default: Disabled)
MAC authentication traps must be enabled at the global level for this attribute to take effect.
FIG. 107
Issuing MAC Address Traps (Global Configuration)
FIG. 108
Issuing MAC Address Traps (Interface Configuration)