![background image](http://html.mh-extra.com/html/amx/modero-s-series/modero-s-series_quick-start-manual_2938711002.webp)
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
2/14
©2014 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-2265-25
REV: A
7.
After installing the back box, inspect the back box’s placement. If
necessary, the back box can be removed and the foam gasket installed.
8.
Pull enough slack on the Ethernet cable through the back box to allow the
cable to reach the touch panel’s RJ45 connector (FIG. 6).
9.
Remove the touch panel’s back box to access the back of the panel.
10.
Insert each connector into its corresponding location along the back of the
touch panel. For more information on connection, please refer to the
Operation Reference Guide for the Modero S Series panel being installed,
available from
www.amx.com
.
11.
Test the incoming wiring by attaching the panel connections to their
terminal locations and applying power. Verify that the panel is receiving
power and functioning properly to prevent repetition of the installation.
12.
Latch the panel onto the top hooks on the back box and rotate it down
(FIG. 7)
.
13.
Press gently but firmly and evenly on the surface of the touch panel until
the top panel snap “clicks” to lock it down (FIG. 8).
WARNING:
if you see a gap between the panel and the back box, or feel any
binding while locking down the panel, stop immediately and verify that no cables
or other items are in the way. Do not force the panel into position, as this can
cause damage to the touch screen or the panel electronics.
Uninstalling the Touch Panel
In order to access the back of the touch panel, such as to install a USB
connection for firmware upgrades, the device may need to be uninstalled from
the back box. To uninstall the touch panel:
1.
From the bottom, pull gently outward from the back box. Gently rock the
panel back and forth to free the bottom from the back box.
2.
Rotate it up to release the top latch hooks, and carefully pull the device
free from the back box. Take care not to damage or pull the connections on
the back of the device, or to pull the back box from the gang box.
FIG. 6
Accessing the Ethernet cable through the back box.
FIG. 7
Hooking the top of the touch panel on the back box.
Pull Ethernet cable
through back box
Top hooks
FIG. 8
Locking down the bottom of the touch panel onto the back box.