For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
3/10
©2010 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-0554-01
REV: B
Step 3 - Prepare and Connect Wiring
1.
Remove approximately 4mm (.18 in) of the wire insulation.
2.
Insert each conductor into the corresponding terminal.
3.
Secure each connection using the terminal screw, according to the schematic
provided in FIG. 5:
Step 4 - Secure the Cable To the Module
Using small provided tie wrap, secure the cable to the circuit card on the backside of
the module, such that the cable exits to the side of the module (FIG. 6).
Step 5 - Insert the Module Into the HPX-1600 Chassis
Insert the module into the main chassis of the HPX-1600 Base Assembly.
Note the position of module interlock tab: this tab should face towards the bottom of
the HPX-1600 Base assembly when installed in its mounted position (FIG. 7).
Step 6 - Install the Bottom Cover On the HPX-1600
Note
: Install any remaining modules into the Hydraport Base Assembly before
installing the Bottom Cover on the HPX-1600.
1.
Install the bottom cover (including the Power Inlet Assembly) onto the bottom of
the main frame of the Hydraport Base Assembly.
The cables from the HPX-AU100-CV+A Composite AV Module as well as all
other modules (except AC Power Outlets) will exit the bottom of the Hydraport
Base Assembly through one of four square passages on either side of the
bottom cover.
2.
After the bottom cover is secured using four screws, secure the cables to the
corresponding tab near each opening using a small cable tie (FIG. 8).
FIG. 5
HPX-U100-BTN Single Button Module - Wiring Schematic
FIG. 6
Cables Secured To the Module
FIG. 7
Inserting the Module into the HPX-1600 Chassis
Anode
Cathode
S1
S2
R = 1.2K
Ω
Tie Wrap
Cables exiting to the side of the Module
Single Button Module
(rear view)
FIG. 8
Bottom Cover - Installed With Cables Exiting and Secured
HPX-1600 Chassis
Aluminum Frame (bottom)
Wire Tie
Wire Tie
Bottom Cover
(secured with 4
mounting screws)
Cable
Cable
