For full warranty information, refer to www.amx.com
12/07
©2007 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-1052-02
REV: A
Front Panel DIP Switches
Each DIP switch pair controls the output gain and peak of the same-numbered
output signal. The default setting is both switches “Off” (down, FIG. 6), which
represents unity gain and no peaking. The gain and peak adjustments can
compensate for long cable runs. To increase brightness of a destination’s video, set
the gain DIP switch to “On”. To sharpen a destination’s video, set the peak DIP
switch to “On”.
To adjust DIP switches:
1.
Using a small screwdriver or paper clip, flip the toggles on the DIP switches up.
See table below for settings.
Flip either or both switches “ON” depending on the length of the cable run.
FIG. 6
Adjust DIP switches for gain and peaking
DIP Switch Settings
OFF (default)
ON
Result
Gain
Unity gain
+0.85 dB
Brightens image
Peaking
No peaking
8 dB @ 150 MHz
8 dB @ 300 MHz
Sharpens image
Example:
Outputs 2, 3, & 6 are set to ON for gain & peaking
Outputs 1, 4 & 5 are set to OFF / unity
