![background image](http://html1.mh-extra.com/html/amx/dvx-2150hd-sp-fg1905-11/dvx-2150hd-sp-fg1905-11_datasheet_2939031004.webp)
4
47-63 Hz
Voltage AC (Typical)
110-240V, 47/63 Hz AC supply
Power Factor Correction (PFC)
Supported, complies with N60555-2 and EN61000-3-2
ENVIRONMENTAL
Temperature (Operating)
0° C to 40° C (32° F to 104° F)
Temperature (Storage)
-10° C to 70° C (14° F to 158° F)
Humidity (Operating)
5% to 85% RH
Heat Dissipation (Typical)
300 BTU/hr
Heat Dissipation (Standby)
200 BTU/hr
ETHERNET
Connection
(1) RJ-45
Description
10/100 Port RJ-45 connector provides TCP/IP
communication. This is an Auto MDI/MDI-X enabled
port, which allows you to use either straight-through
or crossover Ethernet cables. The Ethernet Port LEDs
show communication activity, connection status,
speeds, and mode information
Link/Act Indicator
Link/Activity LED (green) blinks when receiving
Ethernet data packets, one on Ethernet RJ-45
connector and one on the front panel
Speed Indicator
Speed LED (yellow) lights On when the connection
speed is 100 Mbps Ethernet connection and turns OFF
when the speed is 10 Mbps
INTEGRATED AMPLIFIER
Integrated Amplifier
DVX-2150HD-SP: 2 x 25 W RMS into 8 Ohms Class D
stereo amplifier (4-ohm stable)
DVX-2150HD-T: 75 W, 70 V / 100 V mono amplifier
ONBOARD MASTER
Controller
Integrated Controller is the equivalent of a NetLink NI-
2100 Central Controller
Memory
256 MB SDRAM
1 MB Non-volatile (NV) SRAM
256 MB FLASH
Program Port
(1) DB-9 connector that supports RS-232
communications to a PC for system configuration and
diagnostics
Configuration Dip Switch
8-position Master configuration DIP switch allows
setting the Serial Programming port baud rate and
onboard Master execution mode (PRD or normal)
ID Pushbutton
Black ID pushbutton sets the NetLinx Device ID
assignments of the Internal Control Device. It has no
effect on the Internal Switcher Device
Status Indicator
Status LED (green) blinks to indicate that the system is
programmed and communicating properly
Input Indicator
Input LED (yellow) blinks to indicate that the Controller
is receiving data
Output Indicator
Output LED (red) blinks to indicate that the Controller
is transmitting data