![background image](http://html.mh-extra.com/html/amx/control-card-rdc-pdc/control-card-rdc-pdc_installation-sheet_2937824002.webp)
2
RDC-PDC Control Card, Dual or Three Phase
Connecting Dry Closures
Use the 8 (+ common) dry closures with a WPD8 eight-button wall panel.
Each contact closure connection (1 - 8) is pre-programmed with a default
preset. The table below shows the default presets for each contact clo-
sure.
Setting AXlink and PROlink Address Numbers:
Lighting Application Drawings
FIG. 5 Dry closures connection
Dry Closure Default Presets
Contact Closure
Default Function
1
Channel 1 at 100% in 1 second
2
Channel 2 at 100% in 1 second
3
Channel 3 at 100% in 1 second
4
Channel 4 at 100% in 1 second
1
2
3
4
5
6
7
8 COM
Each contact (1 - 8) is pre-
programmed with a default preset.
Refer to the
AMX Lighting Control
System
instruction manual for
details on dry closure default presets
and recording new presets.
Dry Closure Default Presets (Cont.)
5
Channel 5 at 100% in 1 second
6
Channel 6 at 100% in 1 second
7
Pack on (channels 1-6)
8
Pack off (channels 1-6
All other channels are undefined.
FIG. 6 Setting AXlink and PROlink address numbers.
AXlink Address
PROlink Address
Test
Set the AXlink address number
(1-255) for the RDC-DC. This
number must match the device
number in your Axcess program.
Use the PROlink DIP switch to set
the PROlink address number for the
RDC-DC (1-10).
Pin 8 on the PROlink DIP switch is
a test switch that turns all circuits on
to full.
FIG. 7 Method A
Method A
RDC-PDC/120, 3 Phase
6 dimmers, 0 switches