Camrobotics
Installation
7
Installation
Overview
This section describes the installation of the CAM-1000 and the AXP-DTC. For
detailed instructions on installing the AXB-EM232 and the AXB-CAM, refer to the
instruction manuals for those products.
Pre-installation
Setup switches, test points, and adjustment POTs are located behind the front panel
of the AXB-CAM. These have been pre-set for operation of the CAM-1000 and
specified lens. You may need to make adjustments to these settings for your
application. Refer to the
AXB-CAM Camera Controller Instruction Manual
for
information.
If you are not using the optional CC-REL cables, assemble a cable with the 15-pin
D-sub female connector (see Figure 3 and Figure 4) included with the CAM-1000 and
the AXB-CAM.
Pin 1
Pin 9
CAM-1000 Connector Pinouts
Pin
Function
1
Pan
2
Pan
3
Tilt
4
Tilt
5
N/A
6
POTs -
7
Pan POT wiper
Note
If you are building your own
cables, acquire the lens
interface connector from the
appropriate lens manufacturer.
Figure 3
CAM-1000 connector
Figure 4
CAM-1000 connector pinouts
