Control Panel Operation
40
Precis LT Instruction Manual
Note:
When executing a switch, you can select multiple outputs, but only one input.
To select
multiple outputs, you must select the input first (see previous section).
To execute a switch selecting output (destination) first:
1.
Press the Cancel Key.
All the lights on the control panel turn off.
The control panel is in Switch mode.
2.
Press a Level Key to select a level (can be omitted when switching on the default level).
The Level Key illuminates.
3.
Press an Output Key to select an output.
The Output Key flashes, and after a moment if an Input Key is already routed to it, the Input Key
illuminates.
4.
Press an Input Key to select an input.
The selected key illuminates, indicating that it is ready to accept the signal from the input.
5.
Press the Take Key.
All the illuminated keys turn off as the switch is executed.
Disconnecting Inputs & Outputs
Disconnecting a switch deactivates the connection between an output (destination) device and the input
(source) signal that is routed to it. An output can only be connect to one input; therefore, disconnecting
an output only disconnects that connection. If the input is routed to additional outputs, those connections
remain routed.
Be sure to read the information on “Switching Level” on page 39.
You can return to the Switch mode at any time by pressing the Cancel Key. Pressing the Cancel Key does
not cancel any of the disconnects that were just completed.
Note:
To disconnect multiple outputs from an input, use the “Press an Input Key” option in
Step 3 below
.
To disconnect inputs and outputs:
1.
Press the Cancel Key.
All the lights on the control panel turn off.
The control panel is in Switch mode.
2.
Press a Level Key to select a level (can be omitted when switching on the default level).
The Level Key illuminates.
3.
Press an Input Key.
The Input Key flashes, and all the Output Keys the input is routed to illuminate.
Press the illuminated Output Key(s) to disconnect the output(s) from the input.
Each Output Key turns off when pressed.
Press the Take Key.
All the illuminated keys turn off.
The selected outputs are disconnected from the input. Any output keys that were still illuminated
when you pressed the Take Key are still connected.
Or
Press an Output Key.
The Output Key flashes, and the Input Key it is receiving a signal from illuminates.
Press the Input Key.
Press the Take Key.
All the illuminated keys turn off.
The output is disconnected from the input. (Additional outputs may still be connected to the input.)