2
Fig. 3
Fig. 9
Fig. 8
Fig. 7
Fig. 6
Fig. 5
Fig. 4
Fig. 2
Fig. 12
Fig. 10
Fig. 11
a
e
d
Fig. 1
b
c
f
ABOVE COUNTER DIVERTER
INSTALLATION (10-0188-CA)
The
eSpring
®
Water Purifier sits on the countertop with the Diverter and tubing
attached directly to your faucet. It does not work with pull out sprayer faucets.
The tubing should be replaced every two years.
NOTE: Attach the Diverter to a
faucet that will supply COLD,
POTABLE WATER to the Water
Purifier. DO NOT RUN HOT WATER
THROUGH THE WATER PURIFIER.
Check to make sure you have all
the correct components before
beginning installation (Fig 1).
a. Diverter
b. Tubing
c. 3 Faucet Adapters
d. 2 Tubing Supports
e. 2 Tie Straps
f. Tubing Removal Tool
ATTACHING THE DIVERTER
1.
Unscrew
to remove the aerator (wire
screen) and washer from the end of your
faucet (Fig. 2).
2. There are three options for attaching the Diverter to the faucet.
a)
Position
the Diverter onto the faucet and
hand tighten
the textured collar
counterclockwise until secure (Fig. 3).
b) If that does not fit,
attach
the appropriate textured adapter with internal
threads and washer to the end of your faucet (Fig. 4).
c) If the threads on your faucet are internal,
attach
the appropriate adapter
with external threads to the end of your faucet (Fig. 5).
ATTACHING THE TUBING TO THE DIVERTER
1.
Unscrew
to remove the textured nuts (Fig. 6).
2. With the threads facing out,
push
the large nut onto the large tube and the
small nut onto the small tube (Fig. 7).
3.
Firmly push
the large tube onto the large
barb and the small tube onto the small barb
(Fig. 8).
4.
Screw
the nuts onto the barbs and
hand
tighten
(Fig. 9). Use the tie straps to
secure
the tubing to the faucet.
ATTACHING TUBING TO WATER PURIFIER
AND CHECKING FOR LEAKS
**MAKE SURE THE UNIT IS NOT PLUGGED INTO AN ELECTRICAL OUTLET.
1.
Position
the
eSpring
Water
Purifier in a desired location
where the tubing from the
faucet reaches the Water
Purifier and the Power
Adapter reaches an outlet
with continuous power
(Fig. 10).
2.
Remove
the Top Shroud from the Water
Purifier
. Remove the Electronic
Module
(Fig. 11).
3. If the tubing is too long, use a sharp knife
to
cut
the tubes to the same length where
they are NOT BONDED TOGETHER.
Make sure the cut is straight to form a
flat end on the tubes (Fig. 12).
1035795_eng.indd 2
6/10/14 4:56 PM
