Remote Workstation Graphics Card
Page 16
3.3.2
Connect Remote Power Cable (Optional)
Important!
Some workstations may require a RPC to
implement remote power-cycling. See
.
Note:
The DXP4 comes with a generic RPC cable assembly.
However, we recommend that you contact Amulet Hotkey
technical support to make sure this is suitable for your needs.
1.
If required, connect the RPC cable between the motherboard
and the RPC socket on the DXP4. See
2
1
3
4
Figure 7:
RPC.cable.connection
Key to
1.
RPC assembly.
2.
RPC socket on the DXP4
3.
Motherboard
power switch header on the host computer
4.
Front panel power
switch on the host computer
3.3.3 Connect SFP module (DXP4-M only)
1.
Fit the required SFP module into the DXP4-M network socket.
This socket accepts a copper or fibre SFP module. The module
can be 1 Gbit/s or 100 Mbit/s. See the SFP modules datasheet
for more details of available modules.
Figure 8:
Example.SFP.modules
3.4
STEP 4: Connect the DXP4 to the network
1.
Connect a network cable to the DXP4.
3.5
STEP 5: Complete the installation
1. Re-assemble the host computer, make sure all blanking
plates are fitted, and reconnect the power cable.
2. Restart the computer.
The operating system detects the DXP4 and locates the
appropriate drivers.
3.
Make sure you have the appropriate driver for the MXM GPU
on your DXP4. The latest drivers are available on our website.
For further help, contact the GPU supplier or Amulet Hotkey
technical support.
4. Install the driver on the host computer.
5.
(Optional, for the Active Solution only) If required, connect
a local monitor to the DXP4 DisplayPort to complete the host
computer setup.
6.
(Optional) If you need to install a second DXP4 see
install dual DXP4 cards on page 19
7.
(Optional) If you need to install a network extender card see
with a network expansion card (DXEC) on page
Note:
You may not install dual DXP4s and a network extender
card in the same installation.
