Quick Start
• 2-1 •
The H.110 Basic Rate ISDN Board
2.0 Quick Start
This section describes the first steps you should perform to determine if
your Infinity Series H.110 Basic Rate ISDN Board is communicating
correctly with your
Compact
PCI system. You can perform this quick check
without connecting any cables.
The exact procedure will vary depending on which operating system you
are running. For each operating systems, drivers are required to interface
to the boards. The drivers supplied by Amtelco have tests built into them
to verify communications with the boards. These drivers also come
supplied with utility programs that allow the developer to test
communications with the board. Please consult the appropriate
documentation for the driver and operating system you are using.
Quick Start Procedure
1.
With the chassis power off, insert the board into a slot. Note
that the rear board
MUST BE
inserted into the corresponding
rear slot for the board to function.
2.
Turn on the computer.
3.
If the Amtelco driver is not already installed, install it now,
following the instructions supplied with the driver.
4.
Most Amtelco drivers will display a list of boards that are
installed (see the documentation for the particular driver that
you are using). If the H.110 Basic Rate ISDN Board is listed,
skip to step 6.
5.
If the board is not listed, there may be a problem with the
board not being seated correctly in the backplane. There may