AMTC RemoteLink AV Digital Media Player Installation and Operation Guide 11/07/2016 Page 4
Contents
RemoteLink AV Digital Media Player
Power adapter (120VAC input/12VDC 1A output)
(3) 6 ft. audio cable - 3.5mm mono male to 3.5mm mono male
(1) audio adapter - RCA female to 3.5mm mono male
Rubber mounting feet
Mini Philips screwdriver (for adjusting volume controls)
Earphones (for testing audio output)
6 ft. CAT5 Ethernet cable
WifFi antenna
Installation
1. Attach provided rubber feet over screw holes on bottom of player case and place player in desired location.
2. Connect to the Internet
Wired Connection
Connect
one end of the provided 6 ft. CAT5 Ethernet cable to the player’s ETHERNET connector. The other end must
be connected to an RJ45 Ethernet connector which is connected to the internet. Routers/firewalls MUST be
configured as specified on the inside front cover of this guide. Once connected, the player uses Dynamic Host
Configuration Protocol (DHCP) to obtain an IP address and network settings. Alternatively, you may manually assign
a static IP address using the procedure described below.
WiFi Connection/Setting a Static IP Address
Attach the provided antenna to the connector labeled WIFI ANTENNA. Connect a mouse to the USB port of the
player and a TV or monitor to the HDMI connection of the AV Zone. Next power up the RemoteLink AV, and watch for
the settings button during boot. When you see th
is, use your mouse to click “Settings”.
