™
ASD-600 HY-GENIE™
AUTOMATIC LIQUID SANITIZER DISPENSER
INSTALLATION & OPERATION MANUAL
Page 1 of 4
READ BEFORE INSTALLATION:
During the initial installation you may
need to prime the sanitizer 4-5 times to get
the liquid to pump through the spout.
In some cases there may be some
trapped air in the system that does not allow
the sanitizer to initially prime. If this is the case
you will need to blow through the sanitizer filter
to clear the trapped air. Then prime the sanitizer
again. The sanitizer should now prime through
the spout.
For further assistance please call
Technical Support at 1-800-874-7822.
IMPORTANT PRE-INSTALLATION NOTE
Sanitizer Filter
