TSL2541 EVM User Guide
Page 5
If the EVM board is disconnected from the USB bus while the program is running it displays an error
message and then terminates. Reconnect the EVM board and restart the program.
4.2
System Menus
At the top of the window there are pull-
down menus labeled “File”, “Log”, and “Help”. The
File
menu
provides basic application-level control. The
Log
menu is used to control the logging function, and
the
Help
menu provides version and copyright information for the application.
4.2.1 File Menu
The File menu contains the following functions:
Figure 4. File Menu
The
Reread Registers
function forces the program to re-read all of the control registers from the
device and display them on the screen. This does not read the output data, because those
registers are continually read while the program is running.
The
Lux Coefficients
menu allows the user to Display, Load or Save the lux coefficients used to
Click on the
Exit
command to close the main window and terminate the application. Any unsaved
log data is cleared from memory. The application can
also be close by clicking the red “X” in the
upper right hand corner.
4.2.2 Log Menu
The Log menu is used to control the logging function and to save the log data to a file. Log data is
accumulated in memory until it is discarded or written to a data file.
Figure 5. Log Menu
Click
Start Logging
to start the logging function. Each time the program polls the output information
from the device, it creates a new log entry showing the raw data values, the values of various
control registers, and the values entered by the user into the text fields near the bottom right corner
of the window.
Click
Stop Logging
to stop the logging function. Once logging is stopped, the data can be written to
a file, or the user can continue collecting additional data by clicking
Start Logging
again.
The
Log a Single Entry
command causes logging to start, collect one single entry, and
immediately stop again. This function is not available when logging is already running.
