8
CLEARING A JAM
Should a jam occur, the machine will automatically go in the reverse direction for
approximately two seconds, then after a brief pause the machine will automatically
start in the forward direction. This forward and reverse automatic process will
occur three times to clear the jam, if the machine remains jammed after the third
cycle the machine will automatically turn itself off. Ensure that all personnel are
clear of both the input chute and the cutter head.
Momentarily depress the yellow Reverse pushbutton. This will cause the cutters to
run backwards for as long as the Reverse pushbutton remains depressed.
Release the Reverse pushbutton. The machine will come to a stop. After the
machine has completely stopped, press the forward button and try to shred
material.
If machine jams again, reverse shredder, Lock Out Power, and manually remove
offending material.
Re-start machine in the forward direction to resume operation.
NEVER Hold the forward button in the depressed position, as damage to the
machine and the electrical system could occur.
NOTE:
This machine has been engineered to shred many different types of media. If you
are concerned about the ability of this machine to shred a specific media, please
consult the manufacturer before shredding.
SHUT-DOWN PROCEDURE
Allow input chute and output conveyor to clear all material before shut down.
Depress red Stop pushbutton. Remove power cable from receptacle.
Clean any remaining debris from the machine and from the immediate area.
