MODEL 2810E USER MANUAL
2810E UM
REV 7.0
20
6.
MAINTENANCE AND TROUBLESHOOTING
The following section describes the procedures for checking the operation of your 2810E diver
communicator, general maintenance procedures, and how to troubleshoot common problems.
DIVER RADIO COMMUNICATOR CHECK PROCEDURES
6.1
The following are a series of step-by-step procedures to perform a functional check of your
2810E communicator using only a headset. These steps check all communication functions
of the 2810E in both 2-Wire and Full Duplex (4-Wire) mode. If the communicator checks out
using these procedures, then any communication problems are probably located somewhere
else in the system setup.
6.1.1
FULL DUPLEX (4-WIRE) CHECK
This procedure checks the communicator functions in the Full Duplex (4-Wire)
mode.
1.
Set all volume controls to the mid-scale (halfway) position.
2.
Turn the SPEAKER SWITCH off to avoid acoustic feedback.
3.
Turn on the communicator and verify the BATTERY CONDITION
INDICATOR is on or blinking. If the LED does not come on at all, then replace
or recharge the battery. If that does not resolve the problem, then go to the
troubleshooting section to determine the cause.
4.
Identify the microphone and headset leads. When using an Amron headset,
the microphone is the red banana plug and the headset is the black banana
plug.
5.
Plug the microphone lead into the TENDER MICROPHONE (red) jack and
the headset lead into the TENDER HEADSET (black) jack.
6.
Don the headset and talk into the microphone. You should be able to hear
yourself in the headset. Adjust the DIVER TO TENDER VOLUME control and
verify the level can be adjusted to a comfortable level.
7.
Move the headset microphone lead to the DIVER MICROPHONE (red) jack.
Talk into the microphone. You should be able to hear yourself in the headset.
Adjust the DIVER TO TENDER VOLUME control and verify that the level can
be adjusted to a comfortable level.
8.
Move the headset lead to the DIVER EARPHONE (black) jack. Talk into the
microphone. You should be able to hear yourself in the headset.
9.
Connect a source device, such as a MP3 player, to the AUXILIARY AUDIO
INPUT. Set the volume control of the device to low and start playing music.
The music should be heard in the headset. Adjust the volume as required.
Verify that the music is cut off when the PUSH-TO-TALK BUTTON is
pressed.
Summary of Contents for 2810E
