Amprobe Hexagon 60, User Manual

Page: 19 / 22

14
MAINTENANCE AND REPAIR
If the Meter fails to operate, check battery, test leads, etc.,
and replace as necessary.
Double check the followings:
1. Replace the fuse or battery if the meter does not
work.
2. Review the operating instructions for possible
mistakes in operating procedure.
Except for the replacement of the battery, repair of the
meter should be performed only by an Authorized Service
Center or by other qualified instrument service personnel.
The front panel and case can be cleaned with a mild
solution of detergent and water.
Apply sparingly with a soft cloth and allow to dry
completely before using. Do not use aromatic
hydrocarbons, Gasoline or chlorinated solvents for
cleaning.
BATTERY AND FUSE REPLACEMENT
X�
WARNING
To avoid shock, injury, or damage to the Meter:
Disconnect test leads before opening case.
Use ONLY fuses with the amperage, interrupt,
voltage, and speed ratings specified.
Replacing BATTERY follow below steps:
1. Disconnect the test lead probe from measuring
circuit.
2. Turn the Meter to OFF position.
3. Remove the screws from the battery cover and
open the battery cover
4. Remove the batteries and replace with two
1.5V Alkaline Batteries (AAA) or equivalent. Pay
attention to the polarity signs.