MightyMic Pro User Manual
5
Function
Required Action
Answer a Call
Quickly press the “MF” button to answer the call
Rejecting a Call
Press the “MF” button for about 1 second to reject a call
Select Audio Output
After receiving a call, Press the “MF” button for about 1 second to
hear the call through the phone or Bluetooth unit
Ending the Call
Quickly press the “MF” button to end the call or end the call on your
phone
Redial the Last Number
Quickly press the “MF” button twice to redial the last phone number
Answer two calls at the
same time
Hold the “MF” button for about 1 second to answer the second call.
Hold the “MF” button again for 1 sec to switch
Answer two calls one by
one
Quickly press the “MF” button to end the first call. You can then
quickly press the “MF” button again to answer the second call or hold
for 1 second to reject the call
Voice Assistant (Siri)
Hold the “MF” button for about 1 second to start the voice assistant for
your phone
Phone Functions
Charging the Device
Make sure that your device is fully charged before the initial use.
The MightyMic Pro includes a USB-A to USB-C charging cable. This allows you to use any standard
phone charger (not included) to charge the Bluetooth device.
The USB-C connector is a much higher quality than other micro-USB charging ports and can pass
more power for faster charging
Insert the USB terminal of your charging cable into a USB-A Type phone charger and connect the
other terminal to the USB-C jack on the microphone. While charging, the red LED on the front will
remain on. When charging is completed, the LED will turn off
The MightyMic Pro can operate while charging or while being powered by an external battery source
Note: The USB-C charging port does not support data transfer. It is for charging only.
Pairing two Bluetooth devices to one Phone
Depending on the phone and App you may be able to pair the MightyMic Pro microphone and another
type of Bluetooth device at the same time. Such as a Bluetooth gimbal device and Bluetooth
microphone. If the combination does not work correctly you may need to change the pairing order to
get satisfactory results.
Reset the Device
Press the “MF” button for about 8 seconds with the power off. The red and blue LED’s will flash once
then the unit will enter into the pairing mode. Remove previous pairings from the device and re-pair