O
PERATING THE
T
RANSMITTER
8
Operating the Transmitter
Switching the transmitter on/off
Position the transmitter in a good position for the monitoring tasks required
and align the camera lens to the area to be monitored.
Slide the switch to ON. The Power LED lights up green.
The transmitter is now ready to operate.
To switch the unit off, slide the switch to OFF.
Connecting and aligning the transmitter
Night vision
The transmitter is equipped with 4 infrared diodes. This enables the trans-
mission of pictures from areas which are not illuminated. The night vision
function is activated automatically when the light conditions make it neces-
sary.
Check the transmitter and receiver are working properly each time befo-
re the equipment is put into operation.
In the case of a low battery voltage, the Power LED flashes slowly.
In this event replace the 4 x AAA batteries with fresh alkaline cells.
Attention: Position the transmitter with a minimum distance of 1 m to
other electronic devices, otherwise there is a risk of mutual disturbance.
Point the upper section of the transmitter towards the baby or object
you want to monitor. Check that the baby or object is suitably displayed
on the receiver.
When the night−time vision function is activated, the screen display on
the receiver turns to black and white.
Helpline UK 0844 800 6503
(See page 18 for costs and hours of operation)
Summary of Contents for Watch & Care V100
Page 1: ...User Guide Watch Care V100...
Page 19: ...15 Helpline UK 0844 800 6503 See page 18 for costs and hours of operation Appendix...
Page 27: ...23 Helpline UK 0844 800 6503 See page 18 for costs and hours of operation Index...
Page 30: ...Distributed by Audioline GmbH D 41460 Neuss September 2011 Issue 1 2...
