MPA3 V6.3 MOTOR PROTECTION RELAY MANUAL
Issue: R0, Date: 11/2010, CRN: 8168
MPAB010 Rev0
MPA3 V6.2 Motor Protection Relay Manual
Page 6
2
General safety
2.1
Personnel Safety Warnings
2.1.1
Relevant Personnel
Ensure all personnel directly responsible or involved with the installation, operation and maintenance of the
equipment reference this manual in conjunction with any relevant risk assessments to identify all foreseeable
hazards.
2.1.2
Safety Communication
All safety instructions and design requirements within this manual must be communicated to all users. These
requirements are necessary to identify and control any foreseeable risk associated with this piece of equipment. In
the event of any damage or malfunction that results in the potential to harm the health or safety of any person; the
owner/operator should notify the manufacturer immediately.
2.2
Safe Use of Equipment
Equipment supplied has been manufactured within the guide lines of the relevant Australian Standards and state
legislative requirements. Equipment identified within this manual has been designed for a specific intended purpose;
therefore any modification or damage must be reported to the manufacturer for repair.
The instructions within this manual must be observed as an aid towards achieving maximum safety during operation.
2.2.1
Changes to Equipment
Changes in the design and modifications to the equipment are not permitted
2.2.2
Equipment Knowledge
Experience with, or understanding of, this equipment is essential for the safe installation and removal of the
equipment. If in doubt, contact Ampcontrol immediately.
Mechanical and or Electrical installation, and maintenance of plant and equipment, must only be carried out by
appropriately trained, qualified and competent personnel.
