Page 94
Self-Test Mode
With power applied (green LED illuminated) push the SEL button. This will turn off the LED. Press and
hold in the LF button, then press the SEL button again and the printer will enter the Self Test mode.
Self-test will print out all the valid characters in the character sets.
Exit the Self-Test Mode:
After printing out the complete Self-Test list the printer will exit the mode automatically; or
Press the SEL button and the printer will immediately exit the Self-Test mode.
12.18.2
Maintenance
Installing the Ribbon Cassette
The printer has a factory loaded ink ribbon cassette. Remove the power from the printer.
Unlock the front cover by pushing down on the tab at the top of the front panel.
Push the mechanism release button in the top right corner to release the print head.
To remove the ribbon cassette gently pull out the left end then the right.
Replace the cassette by putting the right end of the new cassette slightly onto the drive axle then
gentle pushing the left end into the clips.
The left end of the cassette can only be pressed in after the right end has been correctly seated onto
the drive axle. If alignment is difficult it may be necessary to turn the knob on the cassette slightly.
Now check that the ribbon is tight across the face of the cassette, which is on the inside of the
cassette and across the paper. Turn the knob clockwise again if the ribbon is on the outside of the
cassette.
Figure 119: Paper Access
Ribbon Replacement;
Push back the mechanism head and lock it, close the cover of the printer and reconnect the power.
Loading the Paper Roll
Disconnect the power, unlock and open the front cover.
Push down on the mechanism release button in the top right corner to release the head.
Lift the mechanism as shown below.
Summary of Contents for FireFinder PLUS
Page 1: ...FireFinder PLUS ...
Page 4: ...FIRE BRIGADE RESPONSE GUIDE ...
Page 99: ...Page 92 12 17 3 Panel Interfacing ...
Page 127: ......
