VT50/OM Rev-A
5
1.5
List of Items Furnished
1-Transmitter
1-Type SSMA Plug (Male, SMB Optional) to BNC Jack (Female) Video Adapter Cable
1-Type BNC Plug (Male) to BNC Plug (Male) Video Cable
1-Type MDM-9S (Socket) DC Power Cable
1-Type MDM-9P (Pin) Audio Cable
1-Heatsink (if purchased)
1.6
List of Items Required
Antenna, Type SMA Plug (Male) Connector
Camera, Type BNC Jack (Female) Connector
Video connector adapter to BNC, if camera does not have BNC connector
Microphone(s) (if audio subcarrier(s) specified)
1.7 Environmental
Requirements
AMP Transmitters are designed for indoor or outdoor use. Precautions should be taken
when exposing transmitters to the elements. Do not expose to 100% humidity.
Transmitters should be located in areas where the ambient temperature does not exceed
the maximum operating temperature indicated in the specifications (Section 1.4).
Placement in confined locations with minimal air flow, in direct sunlight in areas of
temperature extremes, or in proximity to other devices which generate heat, such as
power supplies, heating systems, etc., should be avoided. Temperatures exceeding
+75°C may cause permanent damage to the equipment.
When not used for extended periods of time external connections, including power cable,
video cable, and antenna, should be removed and the units covered, boxed, or crated and
stored in a clean, dry place. See Section 1.7 above for environmental requirements.
2.0 SAFETY
PRECAUTIONS
Transmitters should be handled with caution like any electrical or electronic device. Do
not handle the units or associated cabling with wet hands or materials.
Connections should be made only to previously-tested, active power sources (outlets or
batteries) of the correct voltage, and each connector should be inserted only into its
designated port. All connections should be checked to ensure they are firmly in place.
WARNING! RF RADIATION HAZARD
In order to keep the RF Exposure within the FCC 1.1310 limit, a safe personal
distance from the antenna must be maintained according to the below tables. The
first table is for transmitters operating 1500 MHz or higher where the Maximum
Permissible Exposure (MPE) is 10 Watts/meter
2
. The second table is for
transmitters operating in the 340-400 MHz range where the MPE is 2.27
Watts/meter
2
. See Appendix A for details on calculation of safe personal distances.