4
OPERATION INSTRUCTIONS
UNDERSTANDING YOUR AIR COMPRESSOR
•
Hose and Regulator
Use 3/8-inch hose and regulator that has a minimum rating that
exceeds the maximum working pressure of the compressor. The amount of air pressure
released at the hose outlet is controlled by the regulator.
•
ACM Safety Valve
This valve will release excessive pressure if the maximum pressure is
exceeded.
•
Discharge Tube
This tube carries compressed air from the pump to the check valve. Never
touch the discharge tube because it becomes very hot during operation.
•
Unloader
Valve used to release all pressure from the tanks and pump for starting.
•
Check Valve
This is a one-way valve that allows air to enter the tank but prevent air from
going out of the tank.
•
Handle
The handle is provided to move the compressor.
•
Belt Guard
The belt guard covers the belt and pulley.
•
Drain Petcock
Each tank has a drain petcock on the bottom and is used to drain moisture
from the tank. Open the petcock and reduce air pressure below 10 psi and allow moisture to
drain. This should only be done daily to reduce the risk of corrosion.
STARTING YOUR UNIT
•
1.
Move the manual throttle/choke lever into the start position.
•
2.
Put unloader in open position.
This picture
shows open
position.
This is
closed
position
