INSTALLATION & MAINTENANCE GUIDE
–4–
w w w. a m p l i g h t i n g . c o m
–4–
Wire Connection
3
Install Stem to Stake
2
[email protected] • 813.978.3900
–5–
Install Bulb
4
AMP
®
TieredPro Path Light
AAR-3511-B-BZ
Install TieredPro
5
Install/Replace Bulb
6” Stem
Socket
Stake
Pigtail
Wireway Slot
Clear away an area in the ground at
the wireway slot on top of the stake.
Lay the luminaire pigtail into the
wireway slot and screw the stem onto
the stake. If the fixture does not look
straight, adjust by pushing or pulling
on the stake only. Use a bubble level
against the side of stem to make
sure the stem is perpendicular to the
ground.
Pigtail
Main Supply Cable
Wire Connectors
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold separately), connect the leads from the luminaire to the main low
voltage supply cable leads.
Socket
Bulb
Insert the bulb with the correct wattage
and type marked on the luminaire label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch bulb with bare
hands. Use soft cloth to handle bulb.
Place the TieredPro hat over the bulb
and thread onto the top end of the
stem. Hand tighten until snug.
TieredPro Hat
Bulb
Stem
Please reverse Step 2 - Step 4 to expose the bulb and replace it with the
correct wattage and type marked on the luminaire label. Reinstall inner
lens and shade.
IMPORTANT: Bi-Pins must be protected from moisture and dust at all times.
Always reinstall shade and lens when moved.
