[email protected] • 813.978.3900
–5–
INSTALLATION & MAINTENANCE GUIDE
1
2
AMP
®
HydroPro
TM
LED Underwater Light
AUL-8001-25-B-BZ
Install Horseshoe Mount
Wire Connection
Anchor
Horseshoe
Mount
Mounting
Screw
Washer
Place the horseshoe mount on the
desired location and mark (3) points
for the anchors from the holes on the
horseshoe mount.
Drill proper holes on the location and
insert anchors into the drilled holes.
Attach the horseshoe mount onto
the anchors. Pass the washers over
the mounting screws and thread the
mounting screws into the anchors to
secure the horseshoe mount. Hand
tighten until snug with a screwdriver.
NOTE: SOME APPLICATIONS ARE NOT
SUITABLE FOR PERMANENT MOUNTING AND
DO NOT REQUIRE OR WARRANT THE USE OF
SCREWS AND ANCHORS
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold separately), connect the leads from the luminaire to the main supply
cable leads.
Adjust the housing to your desired direction by using the lock nuts on the
side of the housing.
Thumb Screw
Wire Connector
Main Supply Wire
Pigtail
Housing
