–6–
–6–
[email protected] • 813.978.3900
–7–
Wire Connections
3
Hub Body
By using the Allen wrench, loosen screws and remove the cover from
the hub body.
Insert the main supply cable, fixture supply cable, other fixture supply
cable or next hub supply cable into the hub body from the different
conduit. Strip both ends of all cables. Lift the clamps up and insert the
ends of neutral wires into the “NEUTRAL” block. Insert the ends of live
wires into the “HOT” block. Insert the ends of ground wires into the
“GROUND” block. ensure that each wire is pushed into place securely
and close the clamps.
Place the cover back onto the hub body and secure with previously
removed screws. Hand tighten until snug with Allen wrench.
“NEUTRAL” Block
“GROUND” Block
Supply Cable
from Fixture
“HOT” Block
Supply Cable from
other Fixture or
next hub
Screw
Allen Wrench
Cover
Conduit
Adjust Fixture Body Direction
4
Using the Allen wrench, loosen
the screw on the knuckle and
adjust the fixture body to your
desired direction. Once your
desired direction is achieved,
tighten the knuckle down with
the Allen wrench.
ROTATE
Screw
Allen Wrench
Fixture body
