Amity Technology Active Depth Control, Operating And Parts Manual

Page: 6 / 29

Figure 1 ‐ HOME SCREEN
E – “–” Button
This button decreases the target digging depth in increments of 0.2 inches.
F – Digging “Depth” Indicator
This indicator shows the target digging depth of the ADC
unit when it is run in “AUTO” mode. Currently, Figure 1 – F shows a current target depth of 3.4.
PLEASE NOTE: The target digging depth is an arbitrary number. The default Wand setting from
factory will attempt to set target digging depth close to what the actual digging depth
measures. By adjusting the wand height (See “Wand Adjustment” – Page 12), you can change
the relationship between the target digging depth and actual digging depth to your satisfaction.
G – “+” Button
This button increases the target digging depth in increments of 0.2 inches.
H – “AUTO” Button
This button initiates the “AUTO” mode. It turns Green when engaged.
I – Axle Cylinder Height Indicators
The Orange bars on the left and right indicate the
instantaneous height of the axle cylinders. The axle cylinders will vary +/ ‐ 2 inches from the
axle cylinder setpoint. The maximum differential between the cylinders equals 4 inches.
Pressing either of the axle cylinder graphics (Figure 1 – I) will put you into the AXLE CYLINDER
SETPOINT SCREEN (Figure 3 – Next Page)
4