13
IMPORTANT: CHANGING FROM MANUAL USE INTO AUTOMATIC USE REMEMBER TO TURN ON THE
CARRIAGE HANDLE TO CLOSE THE TRANSMISSION (5 FIG.2).
4.4 USE HALF LENGH CARRIAGE CUT
USING THE SLICER IN AUTOMATIC MODE IT IS POSSIBLE TO SELECT ALWAYS THE HALF OR LONG
LENGH OF THE CARRIAGE PUSHING THE BUTTON (4 FIG.2).
THIS SELECTION IS IMPORTANT IF IT IS NECESSARY THE CUT OF SMALL PARTS, IN ORDER TO HAVE
QUICKEST USE OF THE MACHINE.
4.5 SETTING THE FOOD ON THE SLICER SADDLE
1. SET THE FOOD ON THE SADDLE WHEN THE THICKNESS ADJUSTING KNOBIS SET TO ZERO AND
WITH MOTOR OFF TO AVOID DAMAGING THE EQUIPMENT.
2. SET THE FOOD ON THE SADDLE AND BLOCK IT WITH THE FOOD-PRESS (FIG. 3).
3. SET A HAND ON THE FOOD-PRESS AND START THE CUTTING.
4. WHEN THE FOOD IS FULLY SLICED USE THE FRONT PART OF THE FOOD-PRESS TO KEEP THE
FOOD AGAINST THE BLADE.
5. WHEN THE CUTTING IS OVER, PUT OFF THE MOTOR AND STOP THE SLICE THICKNESS ON ZERO
POSITION, THEN REMOVE THE FOOD FROM THE SADDLE.
5) CLEANING AND MAINTENANCE OPERATIONS
5.1 GENERALITIES AND PRODUCTS FOR CLEANING
BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE OPERATIONS, CHECK TO MAKE SURE
THAT THE MAINS SWITCH BE OFF AND THE SUPPLY PLUG DISCONNECTED FROM THE MAINS.
ACCURATELY CLEAN THE EQUIPMENT EVERY DAY FOR A CORRECT OPERATION AND LIFE OF THE
EQUIPMENT.
DESPITE THE SEVERAL SAFETIES, TAKE GREAT CARE TO AVOID CUTTING RISKS WHEN USING THE
BLADE.
CLEAN THE EQUIPMENT WITH THE USUAL NEUTRAL DETERGENTS WHICH MUST NOT CONTAIN
SODA OR ALCOOL. WHEN CLEANING REMOVED ELEMENTS, DO NOT USE A DISH-WASHER FOR NOT
DAMAGING ANODIZED PARTS.
5.2
REMOVAL OF THE FOOD SADDLE
1.
SET THE NUMBERED KNOB “A” ON "0" POSITION TO CLOSE SLICE THICKNESS ADJUSTMENT (FIG.
4).
2.
TURN OFF THE KNOB “B”.
3.
MOVE THE CARRIAGE “C” NEAR THE NUMBERED KNOB AS INDICATED FIG. UP TO THE CLOSE.
4. REMOVE THE COMPLETE CARRIAGE WITH SUPPORT AS INDICATED IN FIG.
T
O REPLACE THE CARRIAGE FOLLOW THE POINT 4 OPPOSITE AND TURN ON THE HANDLE “B” .
THE CARRIAGE CAN BE WASHED UNDER WATER.
ATTENTION!!!! DO NOT REMOVE THE CARRIAGE IF THE BLOCK DEVICE IS NOT ON. WITHOUT THIS
DEVICE THE CARRIAGE CAN NOT BE REMOVED. WHEN THE BLOCK IS ON DO NOT MOVE THE
CARRIAGE OR TURN THE HANDLE.
5.3 REMOVAL OF THE BLADE-COVER
1. LOOSEN THE KNOB OPPOSITE TO THE BLADE (FIG. 5)
2. PUSH THE KNOB TOWARDS THE BLADE AND RELEASE THE BLADE COVER FROM ITS HOUSING.
3. REMOVE THE BLADE-COVER FROM THE SLICER.
THE BLADE-COVER YOU CAN CLEAN IT WITH A WATER JET.
