3. TRANSPORTATION AND STORAGE
The equipment is wrapped in absorbent material and contained and fixed
within a wooden platform and stiff card-board corner, weights and
dimensions are reported in the table (pls. see chapter 11 TECHNICAL
CHARACTERISTICS). Whilst awaiting by definitive collection, these should
be stored within a protected and covered environment at a temperature
between -25° / +55°C, with ambient humidity between 30 to 95%.
4. COMMISSIONING
Carefully read the label on the equipment, do not cover for any reason
whatsoever, and replace them immediately if damaged. Do not remove
protection or panelling that require the usage of tools.
Positioning
Ensure that in respect oft he dimensions (pls. see table
from
chapter 11)
the space reserved for the equipment permits its correct utilisation and
ease of maintenance. After carefully unpacking the display case, remove
the protection film and all of the manufacturer’s material which safeguards
the item in transit. Place the cabinet on a flat surface and level it by
screwing and adjusting the levelling legs to ensure its efficient operation.
The cabinet must be lifted only form the exterior of the base to avoid the
possibility of damage. If the device has been positioned vertically (integral
condensing unit), wait two hours before activating it. The equipment must
not be installed within explosive ambience, in the open air or exposed to
rain, distant form heat sources (radiators, direct lighting, etc.) and
protected from direct sunlight and draughts. Air circulation must be freely
maintained around the condensing unit, be it integral or remote.
Inobservance of these specific conditions will detrimentally affect the
cabinet.
Initial cleaning
Bevor use all parts of the cabinet should be cleaned. For the internal parts
use an antibacterial detergent, for the plastic parts use a moistened cloth.
Dry with a soft clean cloth. Do not use harsh or abrasive solvents or
detergents.
Positioning of components and accessories
All the accessories that can replace the grills are insertable into the same
wall supports that the grills use. Position the grill supports inside the cell
with the spacing most suitable.
Electrical connection
Make suretheelectricalsupply systemcomplies withapplicable laws. The
power cordmust bestretched(avoidtwistingor overlapping) in a position
notexposedto possibleknocks ortampering,should not bein the vicinity
ofliquidor water andheat sources. Ifit is damaged, have it
replacedimmediately by qualified personnel. Always avoidthe useof
adapters.
8
