Amigo Lift-All, Owner'S Manual

Page: 8 / 24

instAlling tHe boom Hold-down
before drilling any holes through the floor in the rear of the vehicle,
note the position of the gas tank and stay clear!
Drill a 11/32-inch (8.7 mm) diameter hole in the floor directly underneath the spool when the boom is folded
down for storage, parallel to the rear door (see figure 8).
install the supplied eye screw through the above hole. thread a nut on the eye screw on the underside of the
floor and tighten securely.
now, lower the boom assembly into the storage position and adjust the shock cord hook to the proper length to hold the
boom down. remove any excess shock cord.
nOte: the shock cord must be adjusted to the proper length to keep the boom assembly from moving freely to avoid
damaging the Lift•All
®
or the trunk lid.
eleCtriCAl instAllAtion
For All VeHiCles
Note: Refer to Electrical Wiring Diagram on enclosed Parts List.
Disconnect your vehicle battery before starting the electrical installation.
route the red wire assembly from the engine compartment through the vehicle into the trunk area. connect the wire to
one end of the circuit breaker. then crimp the ring terminal to the wire in the engine compartment and the insulated, quick-
disconnect terminal to the end in the trunk compartment, trimming the wire to the proper length while allowing a little extra
room for play.
the booster battery bolt provided replaces the bolt holding the positive (+) battery lead to the battery. next,
attach the ring terminal to the battery bolt and tighten securely. install the fuse provided in the fuse holder.
keep the extra fuse in a safe place in case it is needed.
install the wire loom over the red power wire assembly from the battery to the fuse holder and from the fuse
holder to the firewall. use a ty-rap® to secure the wire assembly out of the way.
on CArs
attach the black ground wire assembly from the bottom to the side l-bracket
(#10, figure 5), using the screw and keps nut.
on VAns & suVs
Connect the black ground wire assembly from the Lift•All
®
boom to the vehicle
chassis with the self-tapping screw provided.
note: Make sure the ground attachment point is clean and free from paint,
oil, and carpeting before attaching the ground wire.
install wire loom over the red power wire assembly from the quick-disconnect terminal to the trunk wall.
connect the insulated terminals at the ends of the two red power wires in the trunk compartment.
8 www.myamigo.com