20
MAINTENANCE AND CLEANING
I. Empty the water container
1. Hold and pull out the water container with both hands.
2. Tilt the water container, pour out the condensed water.
3. Insert the water container.
WARNING:
1. Empty the water container after each use. If the water container is full during the drying process, the
programme will be paused and the [
] icon will flash. When the container is emptied, you can restart
the dryer by pushing the [Start/Pause] button.
2. Do not drink the condensed water.
II. Clean the lint filter
1. Open the appliance door.
2. Pull the lint filter upward to take it out.
3. Clean the lint filter; scrape off the threads accumulated on the lint
filter, with your hand or rinse with water and dry thoroughly.
4. Replace the lint filter.
NOTE!
1. Accumulation of lint on the filter impedes the air circulation, which will
cause the extension of drying time and energy use; therefore, the lint filter must be cleaned after each
use.
2. Unplug the power cord before cleaning!
3. Do not operate the dryer without the lint filter !
4. Clean the lint filter after each use to prevent lint accumulation inside the dryer.
III. Clean air condenser
- Allow the dryer to cool down.
- Residual water may escape, so place an absorbent cloth under the maintenance
flap.
1. Unlock the maintenance flap.
2. Completely open the maintenance flap.
3. Undo both locking levers towards each other.
4. Pull out the air condenser.
5. Clean the air condenser completely, drain thoroughly.
6. Clean the seals.
7. Re-insert the air condenser.
8. Tighten both locking levers.
9. Close the maintenance flap until it locks into position. Clean the air condenser
once every 3 months if frequently used. Do not damage the air condenser!
1. Clean with water only. Do not use hard/sharp-edged objects!
Do not operate the dryer without the air condenser!
2. During drying, water may collect between the window and the seal, but
this does not affect the function of your dryer!