26
CLEANING AND MAINTENANCE
Oven is equipped with liners covered with
special self–cleaning enamel. The enamel
removes fat stains or leftover food automa-
tically, providing they are not dried on and
burnt (food and fat remnants should be re-
moved when they are not dried on and burnt
to avoid a long self–cleaning process). To
activate self–cleaning switch on the oven for
1 hour, setting the temperature to 250°C. If
remnants of food are small the process can
be shortened.
If the self-cleaning per for mance is no ticeably
reduced, replace the liners with new ones:
take out the wire rails from the in side and
unscrew the catalytic enamel screw from the
center of the liner. New liners can be obtained
at service outlets.
Removal of catalytic liners
Removing wire shelf supports
Installing wire shelf supports
1
2
1
2
Oven is equipped with easily removable wire
shelf supports. To remove them for washing,
pull the front catch, then tilt the support and
remove from the rear catch.
Replacing the halogen bulb in the oven
Before replacing the halogen bulb, make
sure the appliance is disconnected from
the electric mains to avoid a possible
electric shock.
Oven lighting
● Set all control knobs to the position
“
●
”/“0”
and disconnect the mains plug,
●
Unscrew and wash the lamp cover and
then wipe it dry.
● Pull the halogen bulb out using a cloth or
paper. If necessary, replace the halogen
bulb with a new one.
- voltage 230V
- power 25W
- G9
● Replace the halogen bulb in its socket.
●
Screw in the lamp cover.
Note! Make sure not to touch the halogen
directly with your fingers.