Amibot Swip AS70, User Manual

Page: 14 / 140

12
Operating the robot
EN
Starting the robot
The robot is ready to use when it is fully charged. Remove it from
its home base and place it on the floor. Press the CLEAN button on
the top of the robot to turn it on. Press the CLEAN button again and
the robot starts its cleaning cycle in AUTO mode or you can choose
a cleaning mode as shown below.
NOTE: You cannot switch the robot on using the remote control.
Cleaning modes
The robot has four cleaning modes. These modes can be selected
using the remote control or by pressing the MODE button on the
robot. The selected mode is green on the robot display screen. Then
press the CLEAN button on the robot or select the mode you wish
to use via the remote control. The robot will then start its cleaning
cycle. Once the area is clean, the robot returns to its starting point
and stops its cycle.
NOTE: Before the robot starts its cleaning cycle, make sure there is a space of at
least 50 cm to the sides and rear of the robot.