3” TAF 750
12.2018
/
910101-000116
Page 5 of 17
SAFETY INSTRUCTIONS
General
1.
Prior to installation or any treatment given to the filter, read carefully the installation and operation instructions.
2.
While maintaining the filter all standard safety instructions should be observed in order to avoid danger to the workers, the
public or to property in the vicinity.
3.
Please note, the filters enter into a flushing mode automatically, without prior warning.
4.
No changes or modification to the equipment are permitted without a written notification given by the manufacturer or by its
representative, on the manufacturer behalf.
Installation
1.
Install the filter according to the installation instructions detailed in this manual.
2.
Make sure to leave enough clearance so as to enable easy access for future treatments and safe maintenance operations.
3.
Electric wiring should be performed by an authorized electrician only; using standardized and approved components.
4.
Install main power disconnect cut-off switch close to the control panel.
5.
If the control panel is installed in a location where there is no eye contact with the filter, a power disconnect cut-off switch
should be installed near each filter unit.
6.
Install the filter so as to avoid water splashing directly on the electrical components or on the control panel.
7.
Additional safety devices should be installed on hot water applications to avoid skin burn danger.
Operation, Control and Maintenance
1.
Disconnect the filter from power supply before maintenance or treatment.
2.
Loosening or unscrewing bolts should be done only after the pressure in the filter had been released.
3.
Avoid splashing and water leaking so as to minimize slipping, electrocution or damage to the equipment caused by moisture.
4.
Always open and close valves slowly and gradually.
5.
Remove grease and fat material residues in order to avoid slipping.
6.
After treatment has been completed, re-assemble the protection covers of the drive mechanism.
7.
Manual cleaning of filter element using high water pressure or steam should be performed in accordance with the cleaning
system instructions and without endangering the operator or his vicinity.
8.
Manual cleaning of filter element using acid or other chemical agents should be performed in accordance with the relevant
material safety instructions and without endangering the operator or his vicinity.
Use of Lifting Equipment
1.
While using lifting equipment, make sure that the filter or the lifted part is chained securely and in a safe manner.
2.
Do not leave lifted equipment hanging if not necessary. Avoid working below lifted equipment.
3.
Wear a safety helmet while using lifting equipment.
