6” MCFM - 12000
01.2021
Page 35 of 61
PRIMARY ASSEMBLY INSTRUCTIONS
Insertion of dirt collector (J), fine screen (K), and coarse screen (I)
1.
Slide the dirt collector (J) into the fine screen (K), taking care not to damage the fine screen mesh.
2.
Inspect and grease the fine screen O-rings (L).
3.
Using a fine screen push/pull tool, push the fine screen (K) along with the dirt collector (J) straight into the filter
house (B).
4.
The dirt collector body pipe must go into the bearing at the far end of the filter.
5.
The fine screen O-rings must sit on the intended filter house seats.
For Stainless steel coarse screens:
6.
Insert the stainless steel coarse screen (I) into the filter house (B) and onto the fine screen end. The coarse screen
should extend approximately 8 mm beyond the filter house.
Or - For plastic coarse screens:
6.
Insert the plastic coarse screen (I) into the filter house (B) and engage its threaded end with the threaded end of
the fine screen.
7.
Screw the coarse screen (I) onto the fine screen and adjust it to extend approximately 8 mm beyond the filter
house.
Continue with assembly (for both screens)
1.
Inspect the cover seal (H) and push the service cover assembly (G) straight on to the filter house, whilst inserting
the dirt collector hollow shaft into the guide of the service cover assembly.
2.
Screw the nuts (F) on the filter house stud bolts and tighten.
3.
Connect the booster pump discharge hose to the service cover assembly (G). Use O-ring(M).
4.
Screw bolts (D), washers and nuts (E), and tighten.
Insertion of piston
1.
Inspect and grease O-ring seals that seal the piston to the filter house.
2.
Insert the piston straight into the filter house (B)
3.
Screw nuts (A) and tighten.
4.
Connect pneumatic or hydraulic tubing.
5.
Connect all electrical and control wires.
6.
Connect electrical power supply.
7.
Check that the rotation of the electric motor is in the correct direction.
After assembly, re-commission the filter.