Installation and Operation
AMI
Analyzer Manual
11
f. Connect the analog output if desired. Make sure that the system is set up correctly
for voltage or current output (you can change it if necessary) and wire it with a
shielded twisted pair. Connect the shield to the ground connection shown by the
ground symbol next to the analog output. Note that the output type is defined on
the label on the side of the analyzer.
4. Verify all electrical connections.
5. Power up analyzer.
6. If using the analyzer controls available on the front panel only:
a. Select the desired output range by pressing the “Output Range” button, then
scrolling with the UP or Down buttons.
b. Set the two alarm set points by pressing “Alarm 1” (or “Alarm 2”) and scrolling to
the desired set point.
c. For details on the front panel controls see the chapter in this manual called
“Operation”.
7. If it is desired to use the advanced functions available, purchase the AMI user interface
program and the custom RS-232 cable, and refer to the chapter in the manual called
“Advanced Features and Communications”.
8. Confirm all electrical connections are correct, and the remote devices connected to the
analyzer all work.
9. Seal the electrical seals installed in step 3b above.
10. Screw on the explosion-proof cap.